CAP station lost connection with Server

CAP station lost connection with Server

Issue:
CAP POS throwing "cannot connect to the server" error.

Solution:
1) Open task manager and close software.
2) open CMD and run ping command to server. If good ping signal return time.
3) Check if reconnecting the shared drive will restore. Remap drive if necessary

    • Related Articles

    • Micros Station not connected to network

      Issue#1: Term# not connecting to the network and showing inactive. Issue#2: Can't see the node in file utilities to connect via VNC. Steps taken to troubleshoot... 1) Check network cables. If cables are secure it helps sometimes to disconnect and ...

    • Station Freezes when employee clocks out

      ISSUE: Station freezes after employee clock out 1) Go to Setup in Focus and check the Job unique number. Then test if there is an issue with that job # i.e. 10020 by creating another user with the same job #. do a check out and see if issue repeats. ...

    • Switching Location ISP- Focus

      1- It may help to have site contact to send pics so that you can verify connections and clarify steps for the switch over to new device. 2- If available having contact label the cables with a sharpie often helps particularly where multiple cables ...

    • Internet down. Meraki not taking over network. For SpotOn systems

      ISSUE: site lost network connection and Meraki failover is not taking over to provide service. Troubleshooting: #1 Solution- remove network feed from port one. If site modem is still sending enough signal to the Meraki even if it creates a system ...

    • Work Station Frozen on Payment Screen

      Symptoms: Cashier was taking payment and (typically) after entering a cash payment screen goes gray and will not respond to user ISSUE:  Most likely the user tap/touched some part of screen away from were the "Change Due" screen pops up. This causes ...